Jet Tools DC-650ARC Uživatelský manuál

Operating Instructions and Parts Manual Dust Collector Model: DC-650A/C/ARC/CRC DC-650ARC shown DC-650C shown WMH

10Canister Installation – DC-650C/CRC 1. Place the canister filter so that it fits snugly over the housing and tighten the four knobs (A, Fig. 7). 2

11Electrical Connections All electrical connections must be done by a qualified electrician. All adjustments or repairs must be done with the dust

12Maintenance Never perform maintenance on this machine before turning switch off and removing plug from power source. Failure to comply may cause s

13Parts Replacement Parts Replacement parts are listed in the Parts List on the following pages. To order parts or reach our service department, call

14Index No. Part No. Description Size Qty 35... 331010... Shaft ...

15Parts Breakdown for DC-650C/CRC Models for DC-650A/ARC Models

16Remote Control Breakdown for DC-650ARC/CRC Index No. Part No. Description Size Qty ... DC650RC-100 ... Receiver Assembly (I

17Wiring Diagrams DC-650A/C Models 115V 230V

18DC-650ARC/CRC Models

19Notes

2This manual has been prepared for the owner and operators of the JET DC-650 Series Dust Collectors. Its purpose, aside from machine operation, is to

20 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.com

3Table of Contents Warranty and Service ...

4 Warnings 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on t

5 blahblahblah 20. Make your workshop child proof with padlocks, master switches or by removing starter keys. 21. Give your work undivided attention

6Introduction This manual is provided by JET covering the safe operation and maintenance procedures for models DC-650 Series Dust Collectors. This ma

7Unpacking 1. Remove all contents from the shipping carton. 2. Report any damage to your distributor. 3. Do not discard any shipping material unti

8Assembly The dust collector must be disconnected from the power source during assembly. Failure to comply may result in serious injury! Motor Housi

9 Filter Bag Installation – DC-650A/ARC 1. Thread an M6 hex nut onto the filter bag support rod, followed by an M6 flat washer and M6 lock washer (A