Jet-tools JDP-17FSE Uživatelský manuál

OWNER'S MANUAL JDP-17FSE JET Drill Press WMH TOOL GROUP Consumer/Light Industrial Products Division P.O. BOX 1349 Auburn, WA 98071-

10Assembly 1. Place the base (A, Fig. 1) on a level floor. 2. With a 17mm wrench attach the column assembly (B, Fig. 1) to the base (A, Fig. 1) w

119. With the aid of a second person, carefully lift the head onto the column top. Caution: The head assembly is heavy! Use care when lifting onto

12Adjusting the Depth Stop To drill multiple holes at the same preset depth, use the depth stop: 1. Lower the bit until it touches the workpiece.

13 Speed & Pulley Chart

14Return Spring Adjustment The return spring is adjusted at the factory and should not need further adjustment. If adjustment is deemed necessary:

15 Basic Operation • Always use a back-up piece of scrap wood to cover the table. This protects both the table and the drill bit. • Place materi

16Troubleshooting Trouble Probable Cause Remedy Drill press will not start. 1. Drill press unplugged from wall, or motor. 2. Fuse blown, or circuit

17 Parts Breakdown for JDP-17FSE

18Parts List for JET JDP-17FSE Drill Press Index Part No No. Description Size Qty 1...10800101... Base...

19 Index Part No No. Description Size Qty 57...10705703... Rubber Washer ...

2This manual has been prepared for the owner and operators of a JDP-17FSE Drill Press. Its purpose, aside from machine operation, is to promote safe

20

3 WARNING Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for an

4• USE RECOMMENDED ACCESSORIES. The use of accessories and attachments not recommended by JET may cause hazards or risk of injury to persons. • N

5Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunctio

6230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the po

7On-Off Switch Padlock Model No. BP-1, Stock No. 709736 To safeguard your machine from unauthorized operation and to avoid accidental starting b

8Specifications: JDP-17FSE Stock Number.......

9Contents of the Shipping Container 1. Head Assembly 1. Table 1. Column and Bracket Assembly 1. Base 1. Owner’s Manual 1. Warranty Registration Ca