Jet-tools JJ-6CSDX Uživatelský manuál stáhnout pdf (Strana 22)

Operating Controls

1. Hand Wheel for Outfeed Table

2. Outfeed Table

3. Fence

4. Fence Adjustment Handle

5. Cutter Guard

6. Infeed Table

7. Hand Wheel for Infeed Table

8. On/Off Switch

Operation

Important: If you are inexperienced at jointing, use

scrap pieces of lumber to check settings and get

the feel of operations before attempting regular

work.

Stabilize long workpieces by using an assistant, or

roller stands set level with the outfeed or infeed

table surface.

The fence should be adjusted to create minimum

exposure to the cutterhead during the jointing

operation.

9. Table Lock Knob

10. Fence Tilt Lock Handle

11. Belt Guard

12. Fence Travel Lock Handle

13. Depth Limiter

Check the following before operating the jointer:

 Outfeed table must be set level with the high

point of the knives.

 Fence adjusted for minimum exposure of

cutterhead, and locked at desired angle.

 The cutterhead guard must be in place and

operating properly (except when rabbeting).

 Infeed table set for desired depth of cut.

 Stand away from the cutterhead and turn the

machine on for a few moments. Listen for any

odd noises, rubbings, vibrations, etc. Correct

such problems before attempting operations on

the jointer.

 Carefully check your workpiece for knots, holes,

staples or any foreign material that might

damage knives or pose a risk of kickback. Also

check the workpiece for grain orientation.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Žádné komentáře

Jet-tools JJ-6CSDX Uživatelský manuál Strana 22