Jet-tools HBS-1321W WMH Uživatelský manuál

Operating Instructions and Parts Manual Semi-Automatic Bandsaw Model HBS-1321W WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 60123

10Changing Blades WARNING Disconnect machine from the power source before making any adjustments or repairs! Failure to comply may result in se

11Guide Roller Adjustment The bearings come pre-adjusted from the factory. If adjustment is needed follow the below steps: 1. Disconnect machine

12Blade Tracking Adjustment Since tracking can only be adjusted while machine is running, it is suggested that this adjustment be accomplished by qu

13To change gear box lubricant: 1. Disconnect machine from the power source. 2. Remove drain plug and allow lubricant to drain completely. The d

14Bed and Base Assembly

15Parts List for the JET HBS-1321W Bandsaw Bed and Base Assembly Index Part No. No. Description Size Qty. 1...1321W-01 ...

1621...1321W-21 ...Handle Wheel Assembly ... ...1 21-1...TS-

1750...1321W-50 ...Retaining Pin... ...1 51.

18Arm Assembly

19Arm Assembly Index Part No. No. Description Size Qty. 8-1...1321W-08-1 ...Hose Fitting...

2Warranty and Service WMH Tool Group warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Service Cent

20 103...TS-1524041 ...Set Screw ...M8x16...4 104...

21149-2...TS-1551041 ...Spring Washer ...M6 ...2 149-3...TS-

22...1321W-181B1...Laser Guide with Bracket (not shown) ...1 ...1321W-1

23Wiring Diagram

24Wiring Diagram Symbol Glossary Symbol Description Part Number. LS1 Cut off Limit Switch 1321W-45 LS2 Roller Limit Switch 1321W-45-1 SB1

WARNING • Read and understand the entire instruction manual before attempting assembly or operation. • All JET bandsaws are designed and inte

4Specifications: Model: HBS-1321W Stock Number...

5Uncrating and Cleanup 1. Read and understand the entire manual before attempting setup or operation. 2. Finish uncrating the saw and inspect for

62. Slide the tensioning handle (A, Fig.3) onto the shaft and tighten the hex socket set screw. Electrical Connections WARNING All electrical

7F. Arm Down Button: Depress to lower arm. G. Coolant Switch: Turn arrow to ON starting flow of coolant. Turn arrow to OFF stopping flow of cool

8 WARNING Disconnect machine from the power source before adjusting or changing vise position! Failure to comply may cause serious injury! Adjus

9Changing Blade Speeds Adjust the variable blade speed only while the machine is running. The dial (A, Fig. 6) sticking out of the belt cover (righ