Jet-tools XACTA Uživatelský manuál

Owner's Manual XACTA®Fence II Commercial 30/50 WMH TOOL GROUP 2420 Vantage Drive Elgin, Illinois 60123 Part No. M-708950Z Ph.: 800-274-

10 as shown in Figure 10. Finger tighten only. 5. Install three 1/4-20 x 1-1/2 hex cap screws, three 1/4 flat washers, and three 1/4 nuts into the h

11 XACTA Fence Screw the lock lever knob into the threaded handle on the XACTA Fence II as shown in Figure 14. The lock lever has three functional

12 Adjusting Fence Parallel to the Miter Slot 1. Place the fence next to the outside edge of the right miter slot and lock it. 2. The fence should

13 Parts for the XACTA Fence II Commercial 30/50 Index No. Part No. Description Size Qty 1 ... XF2-101 ...Left Side

14 Parts for the XACTA Fence II Rail Assembly Index No. Part No. Description Size Qty 1 ... XF2-201 ...Front Rail (50

15 Parts for the XACTA Fence II Leg Assembly Index No. Part No. Description Size Qty 1 ... XF2-301 ...Leg ...

16 WMH Tool Group 2420 Vantage Drive Elgin, Illinois 60123 Phone: 800-274-6848 www.wmhtoolgroup.com

2 WARRANTY AND SERVICE WMH Tool Group, Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Serv

3 Table of Contents WARRANTY AND SERVICE ...

4 Warnings 1. Read and understand the entire owners manual before attempting assembly or operation. 2. Read and understand the warnings posted on

5 21. Keep visitors a safe distance from the work area. Keep children away. 22. Make your workshop child proof with padlocks, master switches or b

6 Unpacking Open shipping cartons and check that all parts are intact. Report any damage immediately to your distributor. Read the instruction manual

7 Installation Tools required 7/16" and 1/2" wrenches Cross point screwdriver 3/16" hex wrench Adjustable square Hammer (or rubber mal

8 Back Rail Installation 1. Locate the back rail which is 2" x 2" with holes running along one side only. The height of the back rail when

9 Wooden Extension Table The wooden extension table is an optional accessory. Tools required Electric drill Cross point screwdriver 7/16" and 1