Jet-tools HVBS-56M Uživatelský manuál

OWNER'S MANUALHVBS-56M Horizontal/Vertical BandsawJET EQUIPMENT & TOOLS, INC. P.O. BOX 1349 Phone:253-351-6000A WMH Company Auburn, WA 98071-

10Changing Blades1. Disconnect machine from the powersource.2. Raise the saw arm to the vertical positionand lock in place with lock lever.3. Open bla

11Adjusting Blade TrackingWARNINGBlade tracking adjustment requires runningthe saw with the back cover open! Thisadjustment must be completed by quali

12Adjusting Automatic Shut-OffThe saw should stop after the cut has beencompleted:• If the saw completes the cut and continuesto run, adjust the stop

13Breakdown for Bow Assembly

14Breakdown for Base Assembly

15Parts List for the HVBS-56M BandsawIndex PartNo. No. Description Size Qty.1...TS-0051031 ...Hex Cap Bolt...

16Index PartNo. No. Description Size Qty.52...TS-0081071 ...Hex Cap Bolt... 5/16

17Index PartNo. No. Description Size Qty.99...HVBS462-099 ...Spacer ... ..

2Important Information1-YEAR JET offers a one-year limitedLIMITED WARRANTY warranty on this productREPLACEMENT PARTSReplacement parts for this tool ar

3WARNINGRead and understand the entire instruction manual before operating machine.This machine is designed and intended for use by properly trained a

4Specifications: HVBS-56MStock Number...

5Unpacking and Clean-UpNote: Read and understand the entire manualbefore attempting setup or operation.1. Remove all contents form the shippingcarton.

65. Attach a cross brace to the opposite end ofthe bed using three 5/16”x1” hex cap bolts,six 5/16” flat washers, and secure with three5/16” hex nuts.

711. Slide pulley cover (A, Fig. 5) around motorshaft and worm gear shaft. Secure with twohex cap screws and washers (B, Fig. 5).12. Lift motor with o

84. Remove two screws (D, Fig. 7) and plate (E,Fig. 7).5. Guide blade through slot in table (A, Fig. 8)and fasten table with two screws (B, Fig. 8).6.

9Changing Blade Speed1. Disconnect the machine from the powersource.2. Place saw arm in the horizontal position.3. Loosen tensioning plate hex nut (A,